BUG-O Systems Modular Drive System - Manual (Page 44)

44
STANDARD MAGNET ASSEMBLIES
Hi-Flex Magnet w/ Release
FMD-2325
Holding Power
250 lbs. (113 kg)
For Hi-Flex Rail
Swivel Magnet w/ Release
ARM-2325
Holding Power
250 lbs. (113 kg)
Fixed Magnet w/ Release
ARM-2265
Holding Power
200 lbs. (91 kg)
R.E. On/Off Magnet
ARM-2010
ARM-2010-HH*
Holding Power
250 lb. (113 kg)
Spacer
ARM-2015
Use with
ARM-2010 only
For Semi-Flex Rail
Swivel Magnet w/ Release
ARM-2425
Holding Power
250 lbs. (113 kg)
For Aluminum Rigid Rail
R.E. On/Off Magnet
AFR-2010
AFR-2010-HH*
Holding Power
250 lb. (113 kg)
R.E. On/Off Magnet, Hi-Flex
FMD-2010
FMD-2010-HH*
Holding Power
250 lb. (113 kg)
Spacer Bar
FMD-2015
Use with
FMD-2010 only
Fixed Magnet w/ Release
ARM-2465
Holding Power
200 lbs. (91 kg)
Magnet Plate, Short
ARM-2248
Holding Power
200 lbs. (91 kg)
R.E. On/Off Magnets
The New, Bug-O/ Mag-switch, Switchable On/Off
Rare-Earth magnet assembly provides for quick
rail positioning without fighting the magnet. The
lighter weight, at just 1.7 lb. (.77 kg), less than all
other magnet assemblies, improves handling. 200
lb (90 kg) holding capacity.
*All XXX-2010-HH are “High Heat” models and
are rated at 180°C (356°F) for high temperature
applications.
Swivel Magnets
Magnet bar, swivel with release; recommended
for all applications, combines maximum strength
and versatility. This assembly holds up to 250
lbs. (113 kg) on a flat, clean steel surface.
Short Swivel Magnets
Magnet bar, short; compact for positioning in
hard-to-reach or restricted areas. This assembly
holds up to 200 lbs. (91 kg) on a flat, clean steel
surface.
MAGNET PLATE ASSEMBLIES mount ARR rail quickly and conveniently right on the work surface.
Magnets cannot exert maximum pull on dirty material. Remove excessive paint, scale and rust from the area
on which the magnets will be placed.
KEEP MAGNETS CLEAN - before positioning, wipe off magnetic particles which adhere to the poles.
For
MAXIMUM HOLDING POWER on swivel magnets, press down on top of each side of magnet.... then
rotate until it holds firmly. The magnet will retain its magnetism indefinitely - to preserve the magnet casing,
keep torch 4" (101 mm) away from magnets when burning/welding. Use various thicknesses of keepers to
decrease the magnetic pull when required.