Campomatic AC50MF - Manual (Page 7)

5
When the air conditioner has been connected with the power supply, follow the procedures
given below to operate your air conditioner:
1. Press ON/OFF button to start the unit;
2. Press MODE button to select a desired mode. Keep on pressing the button, the display
shows "AUTO→COOL
DRY HEAT FAN AUTO"in turn.
3. If "COOL", "HEAT"or "FAN" is selected, you may press the FAN SPEED button to adjust
the indoor fan speed. Keep on pressing the button, the fan speed will be set as "AUTO
→LOW →HIGH→AUTO"in turn. But under "AUTO" and "DRY" mode, the fan speed can
not be selected. On "AUTO"operation mode, the fan speed is Auto, on "DRY"mode, the
fan speed is low.
FAN speed display:
When operating manually, the first fan speed symbol displayed indicates low fan, the third
symbol displayed indicates high fan, three symbols displayed simultaneously indicate Auto
fan. After finishing the settings, it displays in a sequences as "First fan speed symbol→Second
fan speed symbol→Third fan speed symbol" . When operating with remote controller, low-frequency
displaying cycle of three symbols indicates low fan or Auto fan; high-frequency displaying cycle
of the symbols indicates high fan or Auto fan.
4. When in "DRY", "COOL","HEAT" or "AUTO" mode, adjust the temperature by pressing the
o "△" and " " button. Each depress of the button, the temperature would increase/decrease 1 C.
5. Press the ON/OFF button to turn off the air conditioner. Please do not stop the unit by pulling
out the power plug or switching off the power supply.
6. When the unit is on, press the ASSIST FUNCTION button, the function displayed as SWING
→ECONOMIC RUNNING→ELECTRICAL HEATING→TIMER ON→TIMER OFF by pressing
the"△"and " " button, press the ASSIST FUNCTION button again to confirm the appropriate
mode.
Note:
When the unit stays waiting, press the ASSIST FUNCTION button, only TIMER ON and
TIMER OFF feature can be activated.
When restart the unit after unplug it from the power supply, the assist function must
be reset; if only turn off the unit without shutting off the power,"SWING" feature can be
restored in memory.
Note: The program time is not accurate to your local time, please reset it.
Setting the AUTO-ON TIMER
1. When the unit is turned to the "off" position(non-operational),to set the AUTO-ON timer,
press the ASSIST FUNCTION button, using the" "and " "button to initiate the TIMER
ON feature (the TIMER ON indicator will flash). Press the ASSIST FUNCTION button again
to register the AUTO TIMER-ON program (the TIMER ON indicator remains on).
2. The time will appear in the display window, press the " " and " " button to select the
desired AUTO-ON time, press the ASSIST FUNCTION button again to register the time.
The unit will start automatically when the specified AUTO-ON time is achieved and operate
under the former operational mode.
Setting the AUTO-OFF TIMER
1. Press the ON/OFF button to turn on the unit.
2. To set the AUTO-OFF timer, press the ASSIST FUNCTION button, using the " "and " "
button to initiate the TIMER OFF feature(the TIMER-OFF indicator will flash), press the
ASSIST FUNCTION button again to register the AUTO TIMER-OFF program (the TIMER
OFF indicator remains on).
→ → → →
△
△
△
△
MANUAL OPERATION
GENERAL OPERATION
△
△
△
△
TIMER SETTINGS