Campomatic Chimney K Series - Manual (Page 6)

personnel.
• Electric Connection
The appliance has been manufactured as class I, therefore earth cable is
necessary.
The connection to the mains is carried out as follows:
If the plug is not provided, connect the electrical load as indicated on the
description label. When a plug is provided, the cooker hood must be
installed in order that the plug is easy to access.
An omnipolar switch with a minimum aperture of 3mm between contacts; in
line with the electrical load and local standards, must be placed between the
appliance and the network in the case of direct connection to the electrical
network.
• The minimum distance between the support surfaces of the cooking pots on
the cooker top and the lowest part of the cooker hood must be at least 65 cm.
If a connection tube composed of two parts is used, the upper part must be
placed outside the lower part.
Do not connect the cooker hood exhaust to the same conductor used to
circulate hot air or for evacuating fumes from other appliances generated by
other than an electrical source.
Before proceeding with the assembly operations, remove the anti-grease
filter(s) (Fig.5) so that the unit is easier to handle.
In the case of assembly the appliance, in the suction version prepare the hole
for evacuation of the air.
• FIXING TO THE WALL
Drill the holes A respecting to the distances indicated (Fig.2).
Fix the appliance to the wall and align it in horizontal position to the wall
units. When the appliance has been adjusted, fix the hood using the screws
A.
For the various installations use screws and screw anchors suited to the type
IEC227 North America
L=live Brown Black
N=neutral Blue White
E=earth Green/Yellow Green