Campomatic WM80K - Manual (Page 12)

12
* COTTON PROGRAM
Note
• If you want to change the setting during operation, press the Start/Pause button to hold the operation and
press the button you want.
• ‘Cold’, ‘30’ °C, ‘40’ °C, ‘60’ °C and ‘95’ ˚C washing temperatures are selectable with Cotton program.
• ‘Prewash’, ‘Rinse+’, and ‘Crease Care’ wash options are selectable with Cotton program.
Caution!
• If you select washing temperature ‘95’ ˚C, some cold water is supplied before the drain of main wash. This
is to protect the user from the hazard of burn injury by lowering the temperature of hot wash water instead
of directly draining it. Therefore this is not a malfunction.
(Be careful with the draining water, since it can be still hot although the temperature is lowered.)
Put the laundry in the drum. Put detergent and softener into the detergent case. Then
close the door.
• Put detergent into the main wash and prewash compartments in the detergent case.
Softener should be below the ‘MAX’ level.
• Put detergent into the pre wash compartment only if you want to add prewash.
• When you want to use bleach, put it into the main wash compartment with detergent.
1
Press the Power button.
• The LED shows only ‘---’ and all Program Lights turn on.
2
Select the ‘Cotton’ program using program selection dial.
• If you press Start/Pause button after power button without selecting program, the
‘Cotton’ program is selected as default program.
• Washing temperature ‘40’ ˚C, spin ‘800’ rpm and rinse ‘3’ times are selected
automatically.
• If you want to change washing temperature, the spin velocity or add wash options
(Prewash, Rinse+, Crease Care), press each button.
3
Press Start/Pause button.
• The Door is locked. By sensing the weight of laundry and supplying wash water,
The appliance starts washing.
4