Caple MOT900 - Manual (Page 7)

7
* Filtering version
Fix the air deflector to the pipe bearing bra-
cket, by using the screws provided.
Fix the pipe bearing bracket to the wall and/
or ceiling (Fig.16), centred to the hood.
Connect the motor air-outlet flange to the air
deflector, by using a suitable pipe. Perform
the electric connection. Place the two orna-
mental pipes on the hood body; lift the inter-
nal pipe up until it reaches the ceiling; then
fix it to the pipe bearing bracket, by using the
two self-threaded screws provided.
WORKING
LUC600 - MOT900 Model (fig. 17)
The rotary knob (fig. 18A) allows you to select
the various functions of the appliance.
All the indicators (fig. 18B) are always lit in
the stand-by function ; functions are selected
sequentially by turning the knob ; the desired
function is set by pressing the knob.
- LIGHTS Indicator (fig. 17C)
This function allows you to switch the lights
on or off; turn the rotary control until the
function is selected, then set it by pressing
the rotary control.
- Timer Indicator (fig. 17D)
By setting this control, at any speed, the ap-
pliance will be switched off after 10 minutes.
It is necessary to select the control again in
order to exit from this function. . When the
Timer function is set , the Timer indicator
will flash and the corresponding speed indi-
cator is lit.
- Speed Indicators (fig. 17E)
They are lit accordingly to the speed set.
OFF Indicator (Fig.17F): This function allows
you to completely switch off the motor; it is
totally lit during selection and setting, while
it is in stand-by afterwards.
MOT900 Model (fig. 18)
The RAZOR model, in addition to the working
features described in the paragraph above,
has an automatic opening and closing system
of the glass panel.
The opening of the glass panel corresponds
to and varies according to the motor speed
set.
The panel is closed automatically, after the
motor is switched off.
A safety device reverses the panel direction in
case of impact with unusual surfaces during
its normal travel.
All of the appliances are equipped with an
electronic device allowing for automatic
switching off after four hour working from
the last operation performed.