Caple MOT900 - Manual (Page 8)

8
MAINTENANCE Tepid water and neutral detergents are re-
commended to clean the appliance, while
abrasive products should be avoided.
The power cord shall be replaced by au-
thorized personnel only.
LED lamp replacement in MOT900 model:
open the glass panel, remove the grease filter
and remove the LED lamp, by tightening the
fixing tongues, and pulling it outwards.
Replace the damaged LED lamp with one of
the same kind.
LED lamp replacement in LUC600 model:
Remove the two fixing screws (fig. 8) and ro-
tate the led light panel , as per (fig. 9). Re-
place the damaged LED lamp with one of the
same kind.
Reinsert the led light panel and fix it by using
the screws previously removed.
An accurate maintenance guarantees good
functioning and long-lasting performance.
Particular care is due to the grease filter.
It can be removed by following the instruc-
tions below:
MOT900:
Open the front glass panel by selecting the
maximum speed, remove the steel grid by
pulling it outwards (fig. 6), then act on the
filter handle and rotate it outwards.
LUC600:
Remove the filter from the hood by pulling it
downwards (fig. 12).
Grease filters are inserted by following the
reverse procedure.
After 30 hour working, the grease filter sa-
turation will be signaled by the simultaneous
lighting of speed indicators; select the timer
function with the hood off to reset it .
The grease filter needs cleaning by regular
hand-washing or in dishwashers, every two
months at least, or depending on its use.
* If the appliance is used in the filtering
version, the activated charcoal filter needs to
be replaced periodically.
The charcoal filter is removed by removing
the grease filter first, following the instruc-
tions above, then by pulling its special pla-
stic tongue until it is released from its seat.
The charcoal filter is inserted by following the
reverse procedure .