Caple WC6215 - Manual (Page 5)

5
¾ Setting The Temperature Controls
• The temperature setting range as below:
Upper compartment: 5～10ºC
Lower compartment: 10～18ºC
• The factory set temperature is as below:
Upper compartment: 6 ºC
Lower compartment: 12ºC
• When the system enters the temperature set up. With each press on the button,
the temperature setting of the upper zone will increase by 1℃ , When the temperature
setting reaches the upper limit of 10ºC, the temperature will return to 5ºC. Each press on
the and temperature setting of the lower zone will lower by 1ºC. When the temperature
setting reaches the upper limit 18ºC, the temperature will return to 10ºC.
• If you wish to view the actual temperature inside the wine cabinet. Please press the
or button and hold for 3 seconds. The actual temperature of the upper zone or the
lower zone will be displayed on the control board. After 5 seconds the temperature will return
to display the set temperature.
• Flashing word= Actual Temperature
Steady word = Set Temperature
¾ Note:
• If the unit is unplugged, power lost, or turned off, you must wait 3 to 5 minutes before
restarting the unit. If you attempt to restart before this time delay, the Wine cabinet will not
start.
• When you use the Wine cabinet for the first time or restart the Wine cabinet after having
been shut off for a long period of time, there could be a few degrees variance between the
temperature you select and the one indicated on the LCD readout. This is normal and it is
due to the length of the activation time. Once the Wine cabinet is running for a few hours
everything will be back to normal.
¾ Functions
• Temperature Memory Function
In the event of a power interruption, the wine cabinet can remember the previous temperature
setting, and when the power is recovered, the cabinet temperature will go back the same
setting as when the power went off.
• Open the Door Alarm
When you forget close the door or the door is not closed completely, the alarm will sound
after 5 minutes. Please close the door completely and avoid the loss of cold energy.
• Temperature Alarm
If inner temperature is higher than 23°C, “HI” is shown on the display panel, and the alarm
will sound after one hour. It will inform that the inner temperature is too high, please check
the reason.
If inner temperature is lower than 0°C, “LO” is shown on the display panel, the alarm will
sound and the malfunction indicator light will be on at the same time.