Caple CR9204 - Manual (Page 20)

20
Adjusting of the minimum of
the top burners
In the minimum position the flame
must have a length of about 4 mm and
must remain lit even with a quick turn
from the maximum position to that of
minimum.
The flame adjustment is done in the
following way:
Auxiliary, semi-rapid and triple-
ring burners
– Light the burner
– Set the gas valve to
position
– Remove the knob
– Using a screwdriver turn the screw F
until the correct setting is obtained
(fig. 3.5).
Inside crown of DuAL burner
– Light the DUAL burner
– Set the gas valve to
position
– Remove the knob
– Using a screwdriver turn the screw
H
until the correct setting is obtained
(fig. 3.6).
Outside crowns of DuAL burner
– Light the DUAL burner
– Set the gas valve to
position
– Remove the knob
– Using a screwdriver turn the screw
G
until the correct setting is obtained
(fig. 3.6).
Normally for LPG, tighten up the
regulation screw.
Fig. 3.6
G
H
F
Fig. 3.5