Caple C3400 - Manual (Page 30)

30
D
G
Fig. 6.17
Fig. 6.14
Fig. 6.13
E
F
Fig. 6.16
H
Fig. 6.15
REASSEMBLING THE INNER PANE
To reassemble the inner pane of the
oven doors operate as follows:
- Make sure the door is locked open
(see fig. 6.10).
- Check the correct positioning of the
no. 4 (four) silicon rubbers D (fig. 6.13).
- Check that you are holding the pane the
correct way. You should be able to read
the wording on it as it faces you.
- Insert the inner pane in the left E and
right F side guides (fig. 6.14) and gently
let it slide up to the retainers H (fig. 6.15).
- Top oven door only: Reassemble the
seal G in the correct way (fig. 6.16) by
hooking the no. 3 fixing hooks in the
proper holes (fig. 6.17).
- Open completely the oven door and
close the lever A on the left and right
hinges (fig. 6.18).
A
Fig. 6.18
It is normal the opened gap between the top
edge of the inner pane and the sealed
gasket. This allows the cooling air circulation.
The bottom
oven door has
not a sealed
gasket in the
top part.
The top oven
door has a
sealed gasket
in the top part.
IMPORTANT NOTE: pay attention not
to exchange the inner panes of the
top and bottom door. The inner pane
of the top door is smaller than the
inner pane of the bottom door.