Wiring details – Cloud Electronics RL-1MB User Manual
Page 13
RL Series and RSL Series Installation Guide v2.0
13
Wiring details
In most cases, remote control plates connect to their host devices via
per-channel, 3-pin 5 mm-pitch screw terminal connectors on the device’s
rear panel. The only exception is the CX163, which has a 4-pin connector.
The connector will be labelled
REMOTE LEVEL, REMOTE LEVEL/
SOURCE, REMOTE MUSIC CONTROL, or something similar,
depending on the device.
On all types of remote control plate, connection at the plate is via a rear 3-pin
screw-terminal connector.
RL Series plates: Connection may be via single- or twin-core screened
cable. RL Series plates can generally be connected to devices that support
remote music source selection with single-core cable, but two-core screened
cable is required when connecting to devices that do not support this.
RSL Series plates: These always require twin-core screened cable.
The use of crimp ferrule-type terminals is recommended for the cable
terminations as this will provide a much more reliable long-term connection.
Recommended maximum cable length is 100 m (328 ft.)