Code Blue 360-DEGREE PEDESTAL MOUNT PUBLIC ADDRESS SPEAKER - Manual (Page 14)

Administrator Guide
Code Blue ● ● ● ● ●

Security bit - to remove phone to access mounting holes.

½-inch concrete bit – to drill holes in wall for the mounting anchors for mounting bolts.

9/16
” socket set - to secure the housing to the wall with mounting bolts.
Electrical preparation: the unit may have supply wires run from either (a) 3.3.2.1
behind the unit through the wall, or (b) below the unit using an external conduit
through the bottom. Holes in the back and bottom have been provided for this
purpose (See
Figure on Page 23).
Remove the top of the unit. 3.3.2.2
Mark the mounting holes. In order to comply with the Americans with 3.3.2.3
Disabilities Act (ADA), the speakerphone button(s) should be positioned between 34
and 48 inches from grade level. Consult an ADA specialist in your area to verify
local and federal guidelines.
Drill all marked holes. 3.3.2.4
Install the housing. Four anchors of appropriate size and type should be 3.3.2.5
used to fasten the housing to the wall (see
Figure 3 on Page 14).
IMPORTANT: If wiring is being supplied from the back, ensure that
the conduit is aligned at this time.
Reattach the top. 3.3.2.6
Ground
– The ground (green) wire should be stripped and fastened to the
3.3.3.1
supplied grounding lug.
24V AC supply
– Using the proper crimping tool, attach a #8 fork to each
3.3.3.2
of the incoming power wires and fasten them to the terminal screws labeled
“Line”
and “Neutral.”
120/240V AC supply – Using the proper crimping tool, attach a #8 fork to 3.3.3.3
each of the incoming power wires and fasten them to the correct terminals as