Compuprint SP40 plus - Manual (Page 25)

User Manual
MAN10239-01 20
Filling in the Printer Setup Forms
To change the values of the parameters, fill in the marker ( ) beside the value you want to set with a black or
blue ball-point pen or a fiber-pen.
Do not use pencils.
AUTOFEED SIGNAL ( ) ( )
disabled * enabled
SLCT-IN SIGNAL ( ) ( )
disabled * enabled
BUFFER CONTROL ( ) ( ) ( )
DTR XON/XOFF* XON/XOFF +
If more than one value is set for a parameter, the printer ignores these parameters and maintains the
currently set value.
Do not fill in the marker beside the title of the preprinted form, otherwise the printer will not be able to read
that page.
For a detailed description of the parameters and values contained in the Configuration and Program1,
Program2, Program3 and Program4 Menus, see “
Setup Parameters ” later in this manual.
For a detailed description of the Offset Tuning procedure, see “ Offset Adjustment ” later in this manual.
Setup Parameters
The following is a listing of the setup parameters.
Configuration Setup ( ) SP40 PLUS : Code Version xxxx
Setup Parameter
Values Description
RESTORE TO MFG No*
all
config
prog. 1, prog. 2
prog. 3, prog. 4 The selected values are not set to factory
defaults.
The values set in all printer setups are reset to
factory defaults.
The values set in the configuration setup are
reset to factory default values
PROGRAM prog. 1, prog. 2
prog. 3, prog. 4
on interface(*) Defines the default Program Setup. Selecting
prog.1, prog. 2, progr 3 or progr.4 the setup
parameters set in the corresponding
Program Setup are set. Selecting on interface
the printer matches the Program 1 settings with
the data arriving on the Centronics interface, the
Program 2 settings with the data it receives from
the serial interface, Program 3 settings with the
data from USB interface and Program 4 setting for
any other optional interface.
When changing from one interface to the other,
the default values are set for the corresponding
Program Setup.
ERROR BUZZER Disable, enable* Enables or disables the buzzer in case of an
error.
JOB BUZZER no beep*,
1 beep, continuous Selects the behavior of the buzzer when a new
print job starts: no signal (no beep), one beep (1
beep) or a continuous signal (continuous).