Compuprint SP40 plus - Manual (Page 26)

User Manual
MAN10239-01 21
Setup Parameter Values Description
INTERFACE TYPE parallel, serial, opt, usb,
automatic* Selects the interface type. In case of printer with
optional interface ports are installed, they are
listed to be selected. Choosing ‘automatic’ the
interface type is selected between all the
available interface ports depending on data
coming from host.
Note: opt. can be dual serial, dual USB, LAN
according to the currently installed optional
interfaces
IBM FINANCIAL No*
honorCTS, ignoreCTS Disables the Financial protocol if IBM 4722 or
IBM 9068 emulation is selected
Enables the IBM FINANCIAL for the IBM 4722
and 9068 protocols. Considers (handles) or
ignores the CTS signal received from host for
the control of the data stream from host
INPUT BUFFER 1 Kb, 8 Kb*, 16 Kb, 32
Kb, 64 Kb Selects the buffer size.
When the 'financial' interface is selected, this
setting is ignored.
IGNORE PE Enabled, disable* Selects whether the printer signals the paper
empty condition (disabled) or not (enabled) on the
busy line.
AUTOFEED SIGNAL Disable*, enabled The parallel interface uses (enabled) or does
not use (disabled) the AUTOFEED signal.
SLCT-IN SIGNAL Disable*, enabled The parallel interface uses (enabled) or does not
use (disabled) the SELECT-IN signal.
BUFFER CONTROL DTR+SRTS*, SRTS,
XON/XOFF, ETX/ACK,
XON/XOFF+DTR+SRTS Selection of the buffer protocol. When the
'financial' interface is selected, this setting is
ignored.
ROBUST XON Enabled*, disabled Perform the Robust XON (enabled) or not
(disabled).
WORD LENGTH 7 bit, 8 bit* Sets the number of the data bits. When the
'financial' interface is selected, this value is
always set to 8 bits.
BAUD RATE 1200, 2400, 4800,
9600*, 19200, 38400
bps Sets the data transfer rate.
PARITY BIT even, odd, space, mark,
none* Selects the parity control for the data.
STOP BIT 1*,2 Selects the number of stop bit.
USB MODE 2.0*, 1.1 Select the USB specification level
COPIES no, yes* Selects the printing on normal paper (no) or on
multicopy format paper (yes)
LOW NOISE No*, yes Disables/enables the low noise function
SAFE BOTTOM EDGE no, yes* Distance from the bottom of the last printer line .
Yes = 5,8 mm from bottom edge
no = 1,5 mm from bottom edge
GET EDGE QUOTE 0/4”, 1/4”*, 2/4”, 3/4”,
4/4”, 5/4”, 6/4”, 7/4 Sets the position in which the left paper edge is
checked. If set to 0, the check is performed at
the first line. The other values correspond to the
physical distance from the first line.
PASSBOOK TYPE Setup
sw control*
Fixed thick*
Vertical
Horizontal Enables the setting made in the current
PASSBOOK TYPE section and the specific
Escape command is not actives.
Enables the specific ESCape command.
Printing a document with fixed thickness.
Printing of passbooks with vertical binding .
Printing of passbooks with horizontal binding