Comtech EF Data CDM-625A - Manual (Page 417)

CDM-625A Advanced Satellite Modem MN-CDM625A
Telnet Command Line Interface (CLI) Operation Revision 3
9–39
Hot
Key Dialog Window
Option Entry
I Tx Backward Alarm Enable Port1
Typical for each entry – Use the ↑↓ arrow keys to select Off or On
J Tx Backward Alarm Enable Port2
K Tx Backward Alarm Enable Port3
L Tx Backward Alarm Enable Port4
M Rx Backward Alarm Enable Port1
N Rx Backward Alarm Enable Port2
O Rx Backward Alarm Enable Port3
P Tx Backward Alarm Enable Port4
Q AUPC Enable Use the ↑↓ arrow keys to select Disable or Enable
R AUPC Remote Demod Target Eb No Enter a value from 0.0 to 14.9 dB
S AUPC Tx Power Max Increase Enter a value from 0 to 9 dB
T AUPC Action On Max Power
Use the ↑↓ arrow keys to select No Action, Generate Tx Alarm
Max Power, or Generate Tx Alarm Minimum ModCod
U
AUPC Action On Remote Demod
Unlock
Use the ↑↓ arrow keys to select Go To Nominal Power, Go To
Max Power, or Hold
V EDMAC Mode Use the ↑↓ arrow keys to select Off, Master, or Slave
W EDMAC Address Enter a value from 0 to 9999
Press a hot key to open a dialog window. Otherwise, press [ESC] to return to the Modem
submenu.