Comtech EF Data C5 User Manual
Page 308
Remote Control Operation
C5/K1/K3 Integrated Satellite Terminal System
B–24
Rev. 0
Receive
Signal Level
Status
Command:
Response:
<add/RSL_'cr'
>add/RSL_xsnn.ndBm'cr''lf']
Where:
x = < or > (data modifier to indicate that the receive
signal level is less than or greater than the returned
value).
s = + or - (receive signal level sign, plus or minus).
nn.n = 0.0 to 99.9 (receive signal level magnitude).
Notes:
1. The 'x' (< or >) parameter is only returned if the level
has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the level cannot be calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the level.
Interface
Buffer Fill
Status
Command:
Response:
<add/IBFS_'cr'
>add/IBFS_nn%'cr''lf']
Where: nn = 1 to 99 (relative to buffer depth).
Current
Sweep Value
Command:
Response:
<add/CSV_'cr'
>add/CSV_xsnnnnn'cr'
CD_yyy'cr''lf']
Where:
x = < or > (data modifier to indicate that the sweep offset
value is less than or greater than the returned value).
s = + or - (sweep offset from center).
nnnnn = 0 to 35000.
yyy = OK or FLT (decoder lock status OK or FAULT).
This command returns the current sweep offset value.
Notes:
1. The 'x' (< or >) parameter is only returned if the level
has exceeded the computational resolution of the
system.
2. 'No Data' is returned if the level cannot be calculated.
3. 'Sampling' is returned if not enough data is currently
available to calculate the level.
Power
Supply
Temperature
Command:
Response:
<add/PST_'cr'
>add/PST_snnn'cr''lf']
Where:
s = + or -.
nnn = 0 to 125 (Degrees Celsius).
Note: 'No Data' is returned if the temperature cannot be read
from power supply.