Comtech EF Data XSAT-7080 - Manual (Page 134)

XSAT7080 X-Band Transceiver Revision 0
50 and 100-Watt Installation MN/XSAT7080.IOM
B–24
Step Procedures
13 Slide bracket (3) over bracket (2).
14
Place flat washer (7) and splitlock washer (8), and nut (10) on bracket (2).
15 Tighten nut to secure the tension strap.
16 Slide two springnuts, (5, figure B-2) into channel of the Unistrut bracket
(1, figure B1).
17 Repeat procedure for second Unistrut bracket (1).
18 Install bracket (1, figure B-10) and secure to the Unistruts with four bolts
(11), and lock washers ( 10 ).
19 Install switch mount bracket (8, figure B-10), to main bracket (1). Secure with
four bolts (11), lock washer (10), and nuts (9).
20 Ensure that the bracket is centered on the Unistruts. Tighten hardware.
IMPORTANT
When installed, ensure the XSAT 100 Watt unit fan is facing outward.
21 Install brackets (1, figure B-2) and secure to Unistrut brackets with four bolts
(6), flat washers (2) and split lock washers (3).
22 Position brackets (1) against center bracket. Do not tighten hardware at this
time
23 Install four bolts (7, figure B-10) with split washers (10) , and flat washers
(2 ) into provided mounting holes in the XSAT 100 Watt casting
24 Carefully lift the unit, and slide the bolt head into the groove of bracket
(1, figure B-10 ).
25 Ensure the washers are between the unit and the bracket. Do not tighten
hardware at this time.
26 Temporary install the assembled waveguide switch (Figure B-18).
27 Ensure that the ports line-up and can be secured. If a gap is present, adjust by
sliding the unit and bracket (1, figure B-2) on the Unistrut (In or Out).