Comtech EF Data DT-4500-A Series User Manual
Dt-4500-a series, Downconverters installation and operation manual
Advertising
IMPORTANT NOTE: The information contained in this document supersedes all previously
published information regarding this product. Product specifications are subject to change
without prior notice.
Part Number MN-DT4500A Revision 1
DT-4500-A Series
Downconverters
Installation and Operation Manual
Advertising
This manual is related to the following products:
Table of contents
Document Outline
- mn-dt4500a_
1.pdf
- INSIDE COVER
- TABLE OF CONTENTS
- TABLES
- FIGURES
- PREFACE
- Chapter 1. INTRODUCTION
- Chapter 2. INSTALLATION
- Chapter 3. REAR PANEL CONNECTORS
- 3.1 Rear Panel Overview
- 3.2 DT-4500-A External Connectors
- 3.2.1 Chassis-mounted Connectors
- 3.2.1.1 AC Power IEC Line Input Connector Module
- 3.2.1.2 Optional DC Power Connection
- 3.2.1.3 J2A | REF IN, External Reference Input Connector (BNC-F)
- 3.2.1.4 J2B | REF OUT, External Reference Output Connector (BNC-F)
- 3.2.1.5 100BASE-TX Ethernet M&C Port (RJ-45)
- 3.2.1.6 P1 | RELAY, Summary Fault Output Connector (DB-9F)
- 3.2.1.7 J1 | COM1 EIA-485/232 Interface Connector (DB-9F)
- 3.2.1.8 Chassis Ground Connector
- 3.2.2 Module-mounted Connectors
- 3.2.1 Chassis-mounted Connectors
- 3.3 Cable Connections
- Chapter 4. UPDATING FIRMWARE
- Chapter 5. FRONT PANEL OPERATION
- Chapter 6. ETHERNET-BASED REMOTE PRODUCT MANAGEMENT
- 6.1 Introduction
- 6.2 SNMP Interface
- 6.3 45xxA Telnet Interface
- 6.4 45xxA Web Server (HTTP) Interface
- Appendix A. REMOTE CONTROL
- A.1 Introduction
- A.2 Communication Interfaces
- A.3 Access Methods
- A.4 Addresses
- A.5 Basic Protocol
- A.6 Message Structure
- A.7 Command / Response Pairs
- A.7.1 Utility Commands
- A.7.1.1 Time
- A.7.1.2 Date
- A.7.1.3 Time Protocol Enable
- A.7.1.4 Time Protocol Server
- A.7.1.5 Local / Remote Status
- A.7.1.6 Media Access Control (MAC) Address
- A.7.1.7 IP Address
- A.7.1.8 IP Gateway
- A.7.1.9 Physical Address
- A.7.1.10 Baud Rate
- A.7.1.11 LCD Contrast
- A.7.1.12 LCD Brightness
- A.7.1.13 Screen Saver Mode
- A.7.1.14 Screen Saver Timeout
- A.7.1.15 VFD Brightness
- A.7.1.16 Reference Oscillator Tuning
- A.7.1.17 Converter Slope Adjustment
- A.7.1.18 Equipment Type
- A.7.1.19 Part Number
- A.7.1.20 Legacy Firmware Information
- A.7.1.21 Firmware Information
- A.7.1.22 Firmware Image
- A.7.1.23 Application Identification
- A.7.1.24 Force Reboot
- A.7.2 Configuration Commands
- A.7.3 Modes
- A.7.4 Status Commands
- A.7.5 Stored Alarms
- A.7.6 Error Processing
- A.7.7 Command Summaries
- A.7.8 User Remote Command Summary
- A.7.1 Utility Commands
- Appendix B. REDUNDANT SYSTEM OPERATION
- B.1 Introduction to Redundancy Operation
- B.2 Backup Downconverter
- B.3 Redundant Configurations
- B.4 Redundant System Configuration
- Appendix C. MAINTENANCE and TROUBLESHOOTING
- METRIC CONVERSIONS
- BACK COVER