A.7.1.4 time protocol server, A.7.1.5 local / remote status, A.7.1.6 media access control (mac) address – Comtech EF Data DT-4500-A Series User Manual
Page 118
DT-4500-A Series Downconverters
Revision 1
Appendix A
MN-DT4500A
A–8
A.7.1.4 Time Protocol Server
Use the TPS command to set the Time Server IP address for the Ethernet management port in the
format xxx.xxx.xxx.xxx.
Command
Details
Set Time Protocol Server: <DEV/TPS_xxx.xxx.xxx.xxx'cr’
Where:
xxx.xxx.xxx.xxx is the Time server IP address.
Confirmation:
>DEV/TPS_xxx.xxx.xxx.xxx'cr'lf']
Retrieve TPS:
<DEV/TPS_'cr'
Confirmation:
>DEV/TPS_xxx.xxx.xxx.xxx'cr''lf']
A.7.1.5 Local / Remote Status
Use the LRS command to enable or disable remote communications interfaces. The factory default
setting is 3 (Ethernet and Serial remote control enabled).
Command
Details
Set Local / Remote
Status:
<DEV/LRS_x'cr’
Where:
x=
0 for front panel control only (remote control disabled)
1 for serial remote control
2 for Ethernet control
3 for Ethernet and serial remote control
Confirmation:
>DEV/LRS_x'cr'lf']
Retrieve LRS:
<DEV/LRS_'cr'
Confirmation:
>DEV/LRS_x'cr''lf']
A.7.1.6 Media Access Control (MAC) Address
Use the MAC command to query the unique MAC address of the unit’s Ethernet management
port.
Command
Details
Retrieve MAC:
<DEV/MAC_'cr'
Confirmation:
>DEV/MAC_xx-xx-xx-xx-xx-xx'cr''lf']
Where:
xx=MAC address byte in hexadecimal