Choosing and preparing a site – Cybex 17001 Jungle Gym User Manual
Page 18
Cybex Owner’s Manual
18
Choosing and Preparing a Site
Before assembling the unit, verify the chosen site meets the following criteria:
•
Area is well lit and well ventilated.
•
Surface is structurally sound and properly leveled.
•
Free area for access to unit and emergency dismount. Minimum clearance is 23.6 inches
(0.6 meters).
•
Adjacent units may share the free area.
It is the responsibility of the facility owner/owner of the equipment to ensure that there is appropriate
clearance around each machine to allow for safe use and passage.
In compliance with the ADA (American Disabilities Act) there must be clear floor space of at least
30 by 48 inches and be served by an accessible route for at least one of each type of exercise
equipment. If the clear space is enclosed on three sides (e.g., by walls or the equipment itself), the
clear space must be 36 by 48 inches.
All other machines must have a clear floor space of 23” for all access point on the machine, unless
shown in the Owner’s Manual.
The dimensions stated in the assembly instructions of this manual include the maximum foot print (in
use) dimensions.
•
Area is not in the vicinity of high humidity, such as in the vicinity of a steam room, sauna, indoor
pool or outdoors. This unit is designed to function normally in an environment with a relative
humidity range of 30% to 75%.
Exposure to extensive water vapor, chlorine and/or bromine could adversely affect the electronics as
well as other parts of the unit.
•
Area maintains an ambient temperature range of 50° F (10° C) to 104° F (40° C) degrees.
Securely anchor machine to the floor
Cybex strongly recommends to maximize stability, equipment must be secured to a solid level
surface.
WARNING: Anchoring equipment:
•
Cybex is not responsible for the actual anchoring of equipment. Consult with a
professional contractor.
•
Use fasteners having a minimum of 500 lbs. tensile capacity (3/8’’ grade 2 bolts or
better).
•
If legs/frame does not contact surface, DO NOT pull down with anchors. Shim
any leg or frame not in contact with surface using flat washers.