D.T. Systems SPT 2420 - Manual (Page 16)

16
TESTING
There are two or three methods you can use to test your
depending upon your model’s features.
First, you should make sure that both the transmitter and
receiver are fully charged. Then, turn on the power to the
Collar Receiver. Next, follow one of these three steps:
To Test the Electronic
Stimulation:
A) Place the tester firmly on
the electrodes of the Collar
Receiver.
B) Set the intensity (Note - An
intensity level setting of 7 or
less might not be enough to
light the tester).
C) Push one of the training but
tons.
D) The tester light will quickly
flash once for the Nick Stimulation and light steadily when
the Constant Stimulation, Jump Stimulation, or Rise
Stimulation button is pushed (the higher the intensity, the
brighter the test light).