Section 3: electrical installation – Daktronics Data Time Series 50 Time & Temperature Displays User Manual
Page 23
Electrical
Installation
3-1
SECTION 3 : Electrical Installation
Reference Drawings:
Eave Mounting of Sensor .........................................Drawing A-15267
Assembly, Term Plate..............................................Drawing A-57279
System Schematic...................................................Drawing A-57319
Schematic, 48” & 60” T&T .......................................Drawing A-67341
Component Access and Controller..........................Drawing A-87841
Knockouts for1/2” conduit are provided in the master display on either end of the display for signal and
power entrance. Refer to the appropriate drawing in Section 1 for dimensions. Figure 1 shows the
general electrical layout of an installation.
3.1
Display Access
Access the inside of the display through the hinged lampbank to perform electrical installation.
The lampbank is held closed with 1/4-turn fasteners along the bottom. Release the fasteners
and swing the lampbank open. Cut the cable ties on the prop rod and secure the lampbank
open.
(25 ft. typical)
(50 ft maximum)
Figure 1: Installation Electrical Layout