Daktronics Sportsound Rack SSR-300 Operation Manual - Manual (Page 23)

Setup & Operation 17
Wireless Mic & Bodypack Operation
1. Open the battery cover. Insert new or fully-charged 9V batteries prior to each use,
and always have spares on hand.
2. Power on the device (Figure 25). Note that with the handheld mic, you must remove
the protective sleeve to access the power and control buttons. Hold MODE until only
the GROUP number is visible. Use SET to select the same group number as the first
receiver unit. Press MODE to continue.
3. Use SET to select the same CHANNEL number as the first receiver unit and then
press MODE to save the settings.
4. Repeat steps 1-3 with the second transmitting device, using the GROUP and
CHANNEL settings of the second receiver unit.
Note: Plug the mic switch into the jack on top of the bodypack unit and plug
headphones/lapel mic into the mic switch.
Verify Reception: With a transmitter and the receiver both turned on and having matching
GROUP and CHANNEL numbers, the RF meter on the receiver should be indicating signal.
Speak into the microphone and the TX AUDIO meter should indicate signal presence.
Figure 25: Wireless Mic & Bodypack Controls