Daktronics Gen V Radio - Manual (Page 10)

4 Setting Radio Channels
Single Controller System
In a single controller system (Figure 3), all radio receivers and all scoreboards receive signal
from the same console at all times. The default channel and broadcast group settings on the
receiver are not typically modified. An example of this type of system is a football field with
a scoreboard in one or both end zones displaying the same information.
Typically all single controller systems will use the default setting BCAST = 1, CHAN = 1.
All jumpers in the radio receivers must be set to Broadcast 1 (BCAST 1).
Display Action
The LCD will toggle between
these 2 screens.
The LCD shows the current radio settings along with a prompt
to accept or modify these values.
If the radio settings are correct press <ENTER>.
If these values are incorrect press <CLEAR>, and the LCD at
bottom left is shown, allowing edit of the channel or broadcast
group setting.
Broadcast Group Setting
1 Use this setting for all single controller systems. Use
the number keys to edit this value and press
<ENTER>
to accept. The asterisk will move to the
channel setting.
Channel Setting
1-8 Channels 1-8 may be used with broadcast group 1.
Edit the channel number to the desired value and press
<ENTER>
to accept. The channel switch on the
receiver must match this value and only the Broadcast
1 (BCAST1) jumper must be set.
Figure 3: Single Control Console
BCAST 1, CHANNEL #1
BCAST 1, CHANNEL #1
BCAST 1, CHANNEL 01
RADI O SETTI NGS
BCAST X CHAN YY
ENTER TO ACCEPT
CLEAR TO MODI FY
BCAST GROUP 1*
RADI O CHAN 01