Daktronics Gen V Radio User Manual
Page 12
6
Setting Radio Channels
Multiple controller systems typically use Broadcast 1 and Channel 1 for the first controller
and Channels 2-8 for all remaining controllers. All jumpers in the radio receivers must be set
to Broadcast 1 (BCAST 1).
Display
Action
The LCD will toggle between
these 2 screens.
The LCD shows the current radio settings along with a prompt
to accept or modify these values.
If the radio settings are correct press <ENTER>.
If these values are incorrect press <CLEAR>, and the LCD at
bottom left is shown, allowing edit of the channel or broadcast
group setting.
Broadcast Group Setting
1
Use this setting for all multiple controllers with single
broadcast group setups. Use the number keys to edit
this value and press <ENTER> to accept. The asterisk
will move to the channel setting.
Channel Setting
1-8 Channels 1-8 may be used with broadcast channel 1.
Edit the channel number to the desired value and press
<ENTER>
to accept. The channel switch on the
receiver must match this value and only the Broadcast
1 (BCAST1) jumper must be set.
ENTER TO ACCEPT
CLEAR TO MODI FY
RADI O SETTI NGS
BCAST X CHAN YY
BCAST GROUP 1*
RADI O CHAN 01