DFI CM901-B - Manual (Page 29)

www.dfi.com Chapter 3 Hardware Installation
29
Chapter 3
Standby Power LED
Standby Power LED
This LED will light when the system is in the standby mode.
Cooling Option
Heat Sink with Cooling Fan
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto CM901-B.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
• “1”, “2” and “3” denote the locations of the thermal pads designed to
contact the corresponding components that are on CM901-B.
Top View of the Heat Sink
Bottom View of the Heat Sink
1
2 3