Digi-Star Cab Control 2000/V - Manual (Page 6)

Cab Control
4
The Cab Control is setup at the factory. There is one selection for the , one for
and twelve selections to enable or disable communications from each of the twelve
available scales. If necessary to re-configure the setup parameters, see below.
- Turn audio alarm or .
- Set Cab Control to turn off after , or ! minutes.
- Disable or enable each of the twelve scale selections.
NOTE: Disabling unused scale selections allow the operator to avoid selecting scales that
are not in use.
Setup Cab Control
1. Follow steps a thru c to enter the setup menu:
a. Turn the unit off.
b. Press {On} while holding either [Net-Gross] or [Select] for 10 seconds.
c. "
#
and will show on the display followed by the current setting.
2. Press [Net/Gross] or [Select] to toggle the buzzer or $ $ .
3. Press [On] to save the setting and advance to
.
4. Press [Net/Gross] or [Select] to select , , or ! .
5. Press [On] to save the setting and advance to the next selection.
6. Press [Net/Gross] or [Select] to enable or disable each of the twelve available
scales.
7. Press [On] to save the setting and advance to the next selection.
8. After scale number twelve has been set, press [On] to exit or [Net/Gross] to run self-
test.
Example below illustrates how to set up a system with two scales. is set to ,
$ $
is set to minutes and Scale #1 and Scale #2 are enabled:
%
$ $ %
" & "
" & ' " & " & (
& ' " & ! " &
" & " & ) " &
" & * " & + " &
NOTE: On systems with six or less scales, use scales numbered 1 through 6.