Digi-Star EZ3400(V) - Manual (Page 28)

Commonly used direct access numbers
D3714-GB Rev B EZ3400(V) User' s manual 24
Delay time
[ DELAY]
Enter the time that the weighing indicator should wait before advancing to the next ingredient to be
loaded.
1. Enter 443.
2. Press .
3. Press , until the required delay time
(seconds) appears on the display: MANUAL, 1, 2,
3, 5, 7, 10, 20, 30, or 60].
4. Press .
Note: If automatically advancing to the next
ingredient is not required, set this setting to
MANUAL.
Drive ratio
[ DRATIO]
Drive ratio is the number of revolutions of the power take-off of the feed mixer divided by the
number of revolutions of the mixer in the feed mixer.
1. Enter 422 .
2. Press .
3. Enter the required drive ratio.
4. Press .
Weighing indicator ID / feed mixer ID
[ SCALEID]
Each weighing indicator has a unique ID number.
1. Enter 108.
2. Press .
3. Press to delete the old ID number.
Enter the new ID number.
4. Press .
Note: The TMR Tracker software ID number
must correspond with the ID number of the feed
mixer.
1
2
2/3
4
443
1
2
3
4
422
1
2
3
4
108
3