Entone Amulet 300 (F1) - Manual (Page 15)

URC 4 User’s Guide
Copyright     2012 Entone, Inc. All rights reserved . 14
v2.5 for URC 4
b. Press the “CH DOWN” key to start searching downward at an approx. 5 seconds interval for each
code set. The TV/AUX mode key will be on and blink every 5 seconds while in the device scan
mode.
NOTE: In this search mode, the remote control will send IR codes from the highest code set number to
the beginning of code set of that device.
5. If the device turns off, a working code has been found. Press OK once to lock in the code. The selected
mode key will blink twice
6. If all code sets of that device is exhausted in the search and the OK is not pressed, the selected device
key will fast blink 7 times and the search mode will be terminated.
NOTE: During the auto-scan, you can press “UP” arrow or “DOWN” arrow to advance to the next device
code immediately without waiting for 5 seconds. You can also use “UP” arrow or “DOWN” arrow to change
the direction of the search.
NOTE: In the programming mode if no key is received within 30s, the device mode key backlight will blink
rapidly for 7 times to indicate an error and then extinguish, and the programming mode will end.