Entone Amulet 300 (F1) - Manual (Page 26)

URC 4 User’s Guide
Copyright     2012 Entone, Inc. All rights reserved . 25
v2.5 for URC 4
Appendix B – Other Features
Showing URC 4 Firmware Version
The URC 4 firmware version is in the format of x.y.z, where x, y and z is digit 0-9. Use the following
procedures to show the URC 4 firmware version:
1. Press “STB” and hold for 5s. The “STB” backlight will illuminate.
2. Press “INFO” once.
3. The 3 digits of the firmware version (x, y and z as described above) will be displayed in the following
manner.
a. The “STB” backlight blinks to indicate the digit. One blink indicates 1, 2 blinks indicates 2, etc
until 9 blinks indicates 9. A 0 is indicates by a shot, long, short, long, short, long blink.
b. In between each digit, the “STB” backlight will be off for 1 second.
c. For example, the following blink pattern shows a firmware version of 2.0.4.
. . .-.-.- ....
NOTE: In the programming mode if no key is received within 30s, the device mode key backlight will blink
rapidly for 7 times to indicate an error and then extinguish, and the programming mode will end.
In addition, the URC 4 Firmware version will also be shown on the sticker inside the battery compartment at
the back of the remote control.
Showing Programmed Device Code
You can display the 4-digit device code by the following procedures:
1. Press and hold “TV” or “AUX” for 5 seconds. The “TV” or “AUX” backlight will illuminate.
2. Press “INFO” once.
3. The 4-digits device code will be displayed in the following manner.
a. The “TV”/”AUX” backlight blinks to indicate the digit. One blink indicates 1, 2 blinks indicates 2,
etc until 9 blinks indicates 9. A 0 is indicates by a shot, long, short, long, short, long blink.
b. In between each digit, the “TV”/”AUX” backlight will be off for 1 second.
c. For example, the following blink pattern shows a device code of 0123.
.-.-.- . .. ...
NOTE: In the programming mode if no key is received within 30s, the device mode key backlight will blink rapidly for 7
times to indicate an error and then extinguish, and the programming mode will end.