Entone Amulet 300 (F1) - Manual (Page 7)

URC 4 User’s Guide
Copyright     2012 Entone, Inc. All rights reserved . 6
v2.5 for URC 4
Here are some principles of the remote registration method:
Each output allows a maximum of 3 RF URC 4 to be registered and a registration list is maintained. If
the user has registered 3 RF URC 4 and tries to register another RF URC 4, the first registered RF
URC 4 will be removed from the registration list. This works as a first-in-first-out fashion.
Each RF URC 4 can only be registered for one output. If user tries to register a RF URC 4 which is
already registered to another output, that remote registration will be removed from the original
registration list.
The registration list is maintained in order. If the secondly registered RF URC 4 is removed from the list,
the third entry will move forth to the second and the third will be blank for a new RF URC 4 to be
registered.
You must install the Remote Antenna Package (RAP) comes with Entone Second Stream Kit before doing
the registration. Please refer to the following sections for installing the RAP.
RAP Installation (in remote room)
Please follow the following diagram to install the RAP. The RAP is used to enhance the URC radio
frequency transmission using the TV coax cable network in your home.
1
Plug the RAP into the TV.
2 Connect the TV coax cable to the RAP and the TV coax network wall outlet.
Figure 2-2 Attaching Remote Antenna Package
NOTE: Don’t let the antenna touch anything.
ATTENTION: If your URC 4 isn’t working very well from far away, you may be experiencing interference
from objects near your receiver. To improve your URC 4’s reception range, try to adjust the antenna
orientation using screwdriver as shown. You may need to try different antenna orientation to achieve the
best reception.
Figure 2-3 Adjusting Antenna Orientation