ETA Tema - Manual (Page 23)

If the cleaner is fitted with telescopic tube B3, adjust its length to fit your figure (Fig. 4).
Floor nozzle B1 is designed to be used to clean carpets or smooth flooring (Fig. 5). If the
floor nozzle is fitted with a brush, pull it out by switching over a flap when vacuuming hard
floorings. You can use crevice nozzle B6 for vacuuming places that are hard to access (Fig.
6). Upholstery nozzle B4 or brush B5 can be used to clean various types of furniture (Fig.
7, 8). The vacuum cleaner can be switched on or off by pushing button A4 marked with the
symbol (Fig. 9). The suction power can be adjusted with the control on hose handle B2
(Fig. 10) or by setting regulation A6 (Fig. 11). The minimum suction power is recommended
for fine fabrics (e.g. curtains, drapes). The maximum suction power is recommended for
floor coverings (e.g. heavy-duty carpets). After finishing work, switch off the vacuum cleaner
and unplug it from the power supply. By switching button A5 with symbol (Fig. 12) the
power cord will be wound automatically. The vacuum cleaner can be held and carried by
handle A9 (fig. 28).
Full dust bag indicator
If the full coloured field shows permanently on the A7 indicator with the tool lifted off the
floor at full power setting, the dust bag must be exchanged (Figure 13). Disregard control
activation during work.
Exchanging the dust bag
After depressing the lock in the back of the lid (Figure 14), lift the lid in the locked position.
Remove the holder with the dust bag (Figure 15) and discard with other garbage. After
lifting the clamp, the dust bag can be removed from the holder (Figure 16). Insert the new
dust bag in the holder so that the slotted edge on the dust bag face rests against the two
mating lugs and press the dust bag face against the mating surface (Figure 17) until the
holder clamp engages. Following the removal procedure in the reverse order, insert the
dust bag with the bag holder in the corresponding grooves in the suction chamber of the
cleaner and click the lid shut.
Exchanging the cloth dust bag
The cloth dust bag can be used for any cleaner model. While the cloth dust bag is not
shipped as standard accessory, it is available separately as a spare part. The cloth dust
bag performs the function of and acts as a full replacement for the paper bag. The cloth
dust bag is removed and reinstalled in exactly the same way as the paper dust bag.
To empty the dust bag, proceed as follows:
1. Remove the bag from the holder and the slide off the clamp bar by pulling it to the side
(Figure 18). The cloth bag will open and the dust bag can be emptied and shaken clean
(Figure 19).
2. Install the clamp bar by following the above procedure in the reverse order. Put the bag
back in its holder and install the holder in the cleaner.
Important precautions
– Never wash or dip the cloth dust bag in water. Never use a damaged cloth dust bag.
– For sanitary reasons we recommend emptying the dust bag outside housing premises.
GB
23 / 40