ETA Grado - Manual (Page 18)

– The product is intended for home use and similar (in shops, offices and similar
workplaces, in hotels, motels and other residential environments, in facilities
providing accommodation with breakfast). It is not intended for commercial use!
– After finishing work and before cleaning, always switch off the appliance and disconnect it
from power supply by taking the power cord connector out of the electric socket.
– Check that the voltage on the type label corresponds to the voltage in your electric power
socket. The power plug must be connected to a properly installed and grounded power
socket.
– Do not remove the socket thermostat B from the grill unless it is unplugged from the el.
outlet and the grill hasn‘t cooled off. Do not plug it into a socket unless it is not inserted
into the grill base A1. Use only the socket thermostat supplied by the manufacturer!
– Do not insert the power plug into the electric power socket and do not pull it out of
the electric power socket with wet hands or by pulling on the power cord!
– Do not use the grill outdoors! Do not use the grill to heat a room!
– Never submerge the socket thermostat B under water (even partially) and do not
wash under running water!
– Do not leave the grill on without supervision and supervise it for the entire time that
food is being prepared.
– Do not use the grill for other purposes (e.g. for drying textile products, shoes, etc.) than
those recommended by the manufacturer.
– Do not place the grill on unstable, fragile or flammable surfaces (e.g. glass, paper,
plastic, wooden-varnished boards and various fabrics/tablecloths).
– Use the grill only in the working position in places, where there is no risk of it being knocked
over and at a sufficient distance from flammable objects (e.g. curtains, drapes, wood, etc.),
sources of heat (e.g. fire stoves, stoves, etc etc.) and wet surfaces (kitchen sinks, wash
basins etc.).
– Before frying remove any food packaging (e.g. paper, PE-bag, etc.).
– When grilling spontaneous combustion of foods is possible. If sudden combustion (fire)
occurs, disconnect the appliance from the power grid and put the fire out.
– Before every connection to the power grid make sure that the temperature control dial
is in the position MIN. After finishing work and before any maintenance always turn
the temperature control dial to the position MIN and disconnect the appliance from the
electrical grid by pulling the power cord plug from the power socket.
– Do not carry the appliance when it is hot, if by chance it is tipped over there is a danger of
a burn injury. Due to high temperature, the pad under the appliance may heat up. Do not
touch it until it cools down.
– The power cord must not be damaged by sharp or hot objects, by an open flame and it must
not be submerged under water. Never place it on hot surfaces and do not leave it hanging
over the edge of a table or a work bench. If the cord is brushed against or tripped over or
pulled by for example children the appliance may tip over or be pulled down and lead to
serious injuries!
– The appliance is portable and is equipped with a flexible power cord with a plug, which
ensures a bipolar disconnection from the electricity grid.
– In terms of fire safety the grill conforms to the norm EN 60 335-2-6. According to this norm
this is an appliance that may be operated on a table or a similar surface under the condition
that in the direction of the main heat radiation, i.e. above the hotplate, a safe distance of
500 mm must be maintained from flammable materials and at least 100 mm in the other
directions.
– If the use of an extension cord is necessary, then it must not be damaged and must meet
the valid norms in force.
18
GB
/ 38