Flowserve U-MAG INNOMAG - Manual (Page 11)

U-MAG ENGLISH 26999990 10-14
Page 11 of 40
Figure 2-3
Assembled units and their
components are heavy. Failure to properly lift and
support this equipment can result in serious physical
injury and/or equipment damage. Lift equipment only
at the specifically identified lifting points. Lifting
devices such as eyebolts, slings, and spreaders must
be rated, selected, and used for the entire load being
lifted.
Crush hazard. The unit and the components can
be heavy. Use proper lifting methods and wear steel-
toed shoes at all times.
Do not attach sling ropes to shaft
ends.
Make sure that the unit cannot roll or
fall over and injure people or damage property.
These pumps use carbon or ceramic silicon carbide
components. Do not drop the pump or subject it to
shock loads as this can damage the internal ceramic
components.
2.4 Storage
Store the pump in a clean, dry location
away from vibration. Leave piping connection covers
in place to keep dirt and other foreign material out of
pump casing.
The pump may be stored as above for up to 6
months. Consult Flowserve for preservative actions
when a longer storage period is needed.
2.5 Recycling and end of product life
At the end of the service life of the product or its
parts, the relevant materials and parts should be
recycled or disposed of using an environmentally
acceptable method and local requirements. If the
product contains substances that are harmful to the
environment, these should be removed and disposed
of in accordance with current regulations.
Make sure that hazardous substances are
disposed of safely and that the correct personal
protective equipment is used. The safety
specifications must be in accordance with the current
regulations at all times.
3 DESCRIPTION
3.1 Configurations
The U-
MAG™ chemical process pumps are
fluoropolymer lined, magnetically coupled, single
stage, centrifugal pumps.
3.2 Nomenclature
The pump size will be etched on the nameplate as in
this example: U012511100-UB0. See Figure 3-1 for
pump identification codes.
3.3 Nameplate
Every U-MAG
TM
pump unit has a nameplate to
provide information on your pump. The nameplates
are located on the adapter with a second tag
containing just the pump serial number affixed to the
casing discharge flange. It is recommended that the
purchaser record the serial number and use it for
reference when requesting information, service, or
parts from your supplier.
Permanent records for this pump are kept by the
serial number and it, therefore, must be used with all
correspondence and spare parts orders. Tag includes
the following:

Pump Model Number: Example – U0

Pump Code: Example – U013711100-UB0

Serial Number: Example – 44001

Impeller Diameter / Max Impeller Diameter
(mm or in.)

Duty Point (Flow/TDH)( m
3
/hr / m or US gpm
/ ft.)

Process Liquid Specific Gravity and
Temperature (°C or °F)