Flowserve XLC Series User Manual
Page 6
Advertising
6
2.12 Slide and reposition the bearing
assembly against the mounting
flange. Secure the housing to the
mounting flange using four (4)
bolts. Tighten bolts to a torque
value of 33 N-m (25 ft-lbs). Verify
the metal-to-metal contact at the
housing joint is unchanged from
the previous step.
2.13 Inject high temperature grease
directly into the grease port
located on the carrier assembly.
Fill with grease until grease is
observed escaping from the
bearing wiper seals. Install a
flexible lubrication line to the
carrier assembly grease port
to enable greasing from the
ground during operation.
grease port
Advertising