Flowserve P-50 Durametallic - Manual (Page 11)

11
4.3.7 Coat the stator O-ring with
silicone lubricant and install it
into the gland ring groove.
4.3.8 Place the gland ring over
the stator being careful to
engage the anti-rotation pins.
See Figure 15.
4.3.9 Install the sleeve collar onto
the sleeve and align the set
screws with the holes.
See Figure 16.
4.3.10 Engage all set screws into
the holes. Back off the dog
point set screws by one quar-
ter turn after bottoming.
4.3.11 Install the centering tabs by
pressing the gland ring down
to compress the springs. Lo-
cate the tab lips into the gap
between the gland and sleeve
collar. See Figure 17.
4.3.12 Apply a light coating of
silicone lubricant to one side
of the gland face gasket to
help the gasket adhere to the
gland.
4.3.13 Rotate the sleeve by hand to
ensure freedom of movement
of the rotating parts.
4.3.14 The P-50 is now ready for
installation. Follow the pro-
cedures in Section 2 of these
instructions for proper installa-
tion.
Figure 15
Figure 16
Figure 17