Flowserve Limitorque MX DeviceNet Field Unit - Manual (Page 36)

Limitorque MX DeviceNet Field Unit FCD LMENIM2328-00 – 11/05
36
4.6.2 View Settings
Refer to Bulletin LMENIM2306, MX Installation and Operation Manual to access the “VIEW SETTINGS”
menu. Verify the settings as follows:
5 View DeviceNet Status
Figure 5.1 – DeviceNet Screens
VIEW DNET STATUS?
This selection permits the User to view pertinent information which summarizes the status of the
DeviceNet option board.
VIEW MODULE STATUS?
Answer "YES" to determine status of individual DN board within the actuator. •
Configuration choices are: •
"OFF" = board installed but turned off •
“OPERATIONAL” – The device is operating in a normal condition. •
"STANDBY" = The device needs commissioning due to configuration missing, incomplete or incorrect. •
"RECOVERABLE FAULT" = Conditions that can cause this event are e.g. communication fault, power •
fault or Limigard fault of the SMT Main Board. Device may need resetting.
"UNRECOVERABLE FAULT" = Internal Diagnostic Fault detected e.g.
•
Receive Queue Overrun •
Transmit Queue Overrun •
CAN Controller Overrun •
Device may need replacing. •
"SELF TESTING" = The device is in self-test mode. •
VIEW NETWORK STATUS?
Answer “YES” to determine status of DN network.
"NOT ON LINE" = Device is not on-line. •
YES
NO
CHANGE
DEVICENET?
(ON)
YES
NO
STATUS
(OFF)-OK?
(CLOSE)
(OPEN)
(STOP)
(POSITION)
YES
NO
ESD ACTION
(IGNORE)-OK?
(CLOSE)
(OPEN)
(STOP)
(POSITION)
YES
NO
COMM LOSS ACTION
(NONE)-OK?
(0-4095)
YES
NO
COMM LOSS DELAY
(60 SEC)-OK?
(0-100%)
* *
YES
NO
MOVE TO
XXX% OPEN
(0-100%)
YES
NO
MOVE TO
XXX% OPEN
(125K)
(250K)
(500K)
(NET CTRL)
YES
NO
BAUD RATE
AUTO-OK?
(0-63)
YES
NO
DNET ADDRESS
NET CTRL-OK?
(0-255)
(0-4095)
YES
NO
ANALOG SCALE
(0-100)-OK
YES
NO
CHANGE PROP
DEAD BAND?
(1-100%)
YES
NO
PROP BAND
(8%)-OK?
(1-?%)
YES
NO
DEADBAND
(2%)
* If POSITION is chosen, as action,
this menu will appear.