Figures, Tables – Flowserve MX-100 Field Unit User Manual
Page 4
MX/DDC-100 Field Unit Installation and Maintenance FCD LMENIM2329-01 – 03/11
4
Figures
Figure 1.1 – Typical DDC-100 system with or without a Master Station II
6
Figure 2.1 – MX-05 actuator
8
Figure 2.2 – DDC-100 field unit
9
Figure 2.3 – Typical direct-to-host arrangement
10
Figure 2.4 – Typical Master Station II (rear view)
11
Figure 2.5 – Redundant connection operation in redundant host loop topology
12
Figure 3.1 – Network connections
30
Figure 3.2 – Removing outer plastic jacket
31
Figure 3.3 – Separating cable parts
32
Figure 3.4 – Stripping conductors
32
Figure 3.5 – Applying heat shrink tubing
33
Figure 3.6 – Ring tongue connectors
33
Figure 3.7 – Connecting network cable to MX terminal block
34
Figure 3.8 – Redundant bi-directional loop topology
36
Figure 3.9 – Daisy chain topology
37
Figure 3.10 – Error Messages
44
Figure A.1 (1 of 2) – Typical MX/DDC-100 wiring diagram
52
Figure A.1 (2 of 2) – Typical MX/DDC-100 wiring diagram
53
Figure A.2 - MX Terminal block
54
Tables
Table 2.1 – Modbus function codes supported
14
Table 2.2 – DDC-100 coil assignments, Modbus 05 command usage for digital outputs
14
Table 2.3 – Status Bit Definitions
15
Table 2.3 – Status Bit Definitions (continued)
16
Table 2.4 – Register definitions
18
Table 2.4 – Register definitions (continued)
19
Table 2.4 – Register definitions (continued)
20
Table 2.5 – DDC-100 coil assignments, Modbus 05 command usage for digital outputs
22
Table 2.6 – Modbus 06 command and field unit holding register 40001
24
Table 2.7 – Diagnostic Codes Supported by the DDC-100 Field Unit
27
Table 3.3 – Network cable terminations
34
Table 3.4 – MX/DDC digital input configurations (only one selection per row is permitted)
42
Table 3.5 – MX/DDC digital inputs (cross-reference of various inputs)
42
Table 3.6 – Digital input voltages
43
Table 3.7 – MX/DDC digital outputs S1-2 and R1-8
43