Installation – Flowserve NRS1-8 User Manual
Page 12
Advertising
Tools
n
Screwdriver (5.5/00)
Attention
n
To provide sufficient ventilation, ensure a minimum spacing of 0 mm between
adjacent units.
Installation
NRS 1-8
On supporting rail (with mounting clip)
. Clip level switch onto supporting rail.
. Loosen cover screws
A and unplug cover C from its base B.
3. Select cable entry
E / F and remove corresponding seal.
On mounting panel
. Loosen cover screws
A and unplug cover C from its base B.
. Unscrew mounting clip
D.
3. Drill the hole
G marked in the base to ∅ 4.3 mm.
4. Fasten base with two screws M4 onto mounting panel.
A
Cover screws
B
Base
C
Cover
D
Mounting clip
E
Cable entry (flexible)
F
Cable entry (housing)
G
Hole d = 4.3 mm
H
Supporting rail 35 x 5 mm to DIN EN 500
Key
Advertising