Security – Foxconn nT-i2847 User Manual
Page 22
3
17
Security
► Administrator Password Status
This item is used to install or change administrator password.
After you input administrator password, it then will ask you to confirm the password.when the
password has been set up , the following interface will be displayed.
► User Password Status
This item is used to install or change user password.
► Security option
To protect the BIOS from being changed by the unauthorized users, there is a security option
provided for your choice. Only when there exists an Administrator password, then this setting
can be activated.
[setup]:A password will be required to enter the BIOS.(Only check password when enter setup)
[Always]:A password will be required to enter both the system and BIOS. (Always check
password)
► ME Flash Write Protect
This item is used to enable or disable ME Flash Write Protect.
Version 2.15.1231. Copyright (C) 2012 American Megatrends, Inc.
Aptio Setup Utility - Copyright (C) 2012 American Megatrends, Inc.
Main Advanced Power Security BootOptions Save & Exit
Administrator Password Status
Not
Installed
User Password Status
Not Installed
Change Supervisor Password
ME Flash Write Protect
[Enabled]
↑ ↓→ ←: Move
Enter: Select
+/-: Change Opt
ESC: Exit
F1: General Help
F2: Previous Values
F3: Optimized Defaults
F4: Save & Exit Setup
F7:
Load User-defined Defaulta
F8: Save as User-defined
Valid Keys:
(1)a-z (A-Z)
(2)0~9
(3)11 special keys:-=[];,./
(2)key pad:0-9 support and 5 special
keys
Security