Fronius IG 300 - Manual (Page 32)

24
„Day“ / „Year“ /
„Total“ display
mode
„Year“ display mode ... Displays values for power fed into the mains during the current
calendar year - only in conjunction with a data logger
„Total“ display mode ... Displays values for power fed into the mains since the FRONIUS
IG was originally commissioned.
- Select „Day“ / „Year“ / „Total“ display mode (see chapter entitled „The Display“)
- The first display function of the selected display mode will appear
* Optional - If the necessary sensor card is not present, the letters “N.C.” are display-
ed.
„Day“ display mode ... Displays values for power fed into the mains during that day
Important! Switch-on time represents the beginning of the working day for the FRONI-
US IG. If the DC-in lead is disconnected, the following values will be reset after the unit
has been restarted.
- Return (currency can be selected)
- CO
2
reduction (kg)
- Maximum power fed into the mains (watts)
- Maximum mains voltage (volts)
- Minimum mains voltage (volts)
- Energy taken out of the mains (kWh)
- Service hours completed by the FRONIUS IG
The above instruction does not apply if an optional datalogger is being used. If the
optional datalogger is available, the totalled display values apply in any case to the whole
day of feeding power into the mains.
Energy fed in ... Energy fed into the
mains over the period of time in
question (kWh / MWh)
There may be discrepancies with values displayed on other measuring instruments
because of differences in methods of measurement. As far as adding up the energy fed
in is concerned, the only binding display values are those produced by the calibrated
measuring device provided by the electricity supply company.
- You can access the next value by pressing key (B)
- Use key (A) to scroll back
(A) (B)
* Time (optional datalogger) ... if the
time is changed on a FRONIUS IG or
an add-on system component, it will
also be changed in any other devices
that are connected via LocalNet. Overview of
display values
(continued)