Dixon SpeedZTR 965882301 - Manual (Page 30)

OPERATION
30- DIXON
Engage the mower deck by pulling out the 6.
blade switch.
Move throttle control to full throttle (not choke).
7.
The machine’s speed and direction are
continuously variable using the two steering
controls. When both controls are in the neutral
position, the machine stands still.
By moving both controls an equal amount
forward or backward, the machine moves in a
straight line forward or backward respectively.
In order, for example, to turn right while moving
forward, move the right control towards the
neutral position. The rotation of the right wheel
is reduced and the machine turns to the right.
Turning on the spot can be achieved by
moving one control backward (behind the
neutral position) and carefully moving the
other steering control forward from its neutral
position.
IMPORTANT INFORMATION
Control levers return to neutral when released.
This may cause the mower to suddenly stop.
Operating On Hills
Read the Safety Instructions “Driving on Slopes” in the
“Safety Instructions”.
The slowest speed possible should be used •
before starting up or down hills.
Avoid stopping or changing speed on hills.
•
If stopping is absolutely necessary, pull drive •
levers into the neutral position and push to
the outside of the unit and engage the parking
brake.
To restart movement, release the parking •
brake.
Pull the control levers back to the center of the
•
mower and press forward to regain forward
motion.
Make all turns slowly.
•
WARNING!
Do not drive up or down hills with
slopes greater than 10 degrees. Do not
drive across slopes.
8050-781
Set blade engagement and throttle control
8061-020
Place controls in neutral position
8058-020
Released parking brake