Dixon SpeedZTR 965882301 - Manual (Page 45)

DIXON -45
MAINTENANCE
WARNING!
The machine must be standing
absolutely still when the park
brake is engaged.
Visually check that no damage is found on the lever,
linages, or switch belonging to the parking brake.
Perform a stand still test and check that there is a
braking action.
To adjust the parking brake, contact the Dixon service
workshop.
Parking Brake
WARNING!
Faulty adjustment can cause an
accident.
V-belts
Check every 100 hours of operation. Check for severe
cracking and large nicks.
NOTE: The belt will show some small cracks in normal
operation.
The belts are not adjustable. Replace belts if they
begin to slip from wear.
Deck Belt
Park on a level surface. Apply parking brake. 1.
Lower the deck into the lowest cutting position. 2.
Remove bolts from belt shields and remove 3.
shields.
Remove any dirt or grass that may have
4.
accumulated around the cutter housings and entire
deck surface.
Carefully roll the belt over the top of the cutter
5.
housing pulleys and remove belt.
Removing deck belt
Belt Shields
8058-020
Released parking brake