GAI-Tronics 10959-201 and 10959-203 Wall-mount Audio Messenger Interface - Manual (Page 7)

Pub. 42004-403F
M ODEL 10959-201 AND -203 W ALL -M OUNT A UDIO M ESSENGER I NTERFACES P AGE 5 of 20
f:\standard ioms - current release\42004 instr. manuals\42004-403f.doc
11/13
Installation
Power Disconnect. The power cord is the main power disconnect for all units.
Disjontion de l’alimentation. Le cordon d’alimentation est la disjonction d’alimentation principale tous les appareils.
Para Desconectar la Alimentación: El cable de alimentación es el medio principal de desconexión del equipo.
Netzanschluß. Wenn man das Netzkabel aus der Steckdose zieht, dann ist die Spannungszuführung zum Gerät vollkommen
unterbrochen.
CAUTION To reduce the risk of fire, use only No. 26 AWG or larger telecommunication line cord.
ATTENTION Pour réduire le risque d’incendie, utiliser uniquement des conducteurs de télécommunications 26 AWG ou
de section supérieure.
PRECAUCIÓN Para aminorar la posibilidad de incendios, utilice solamente cable de telecomunicaciones de calibre 26
(sistema AWG americano) o mayor.
VORSICHT Um die Brandgefahr zu verringern, verwenden Sie bitte nur Fernmeldekabel der Stärke Nr. 26 AWG oder
höher.
Mounting
1. Loosen the four screws on the front cover. Open the front cover of the enclosure to the left.
2. Remove the cable connections between the front panel and rear enclosure.
3. Pull on the left side of the enclosure until the hinge pins pull loose to separate the front and rear
sections. Set the front half of the enclosure aside.
4. Determine the conduit or cable gland location on the rear enclosure. Drill spots have been provided
on top and bottom for use with either a chassis punch or hole saw. Cut or punch the appropriate size
hole(s) in the enclosure.
5. Use Myers ST-4 (1.25 inches) Scru-Tite hubs or equivalent. Reducers must be used for smaller
conduit sizes to ensure proper contact with the supplied grounding plates. The hub(s) must be
connected to the conduit before being connected to the enclosure.
6. Each mounting hole in the enclosure is 0.280 inch in diameter. Secure the rear enclosure on the wall
with screws or appropriate fasteners.
7. Route the dc power, audio, input/output control, and phone line through the conduit and into the
enclosure allowing adequate cable length to access terminal blocks.
8. Re-install the hinged front cover and re-connect the cables to the front panel.