Programming and set up, Opening the voip paging module assembly – GAI-Tronics 10458-701 VoIP & VoIP WiFi Electronics Paging Modules User Manual
Page 14
Pub. 42004-464B
Model 10458-701 and 10458-801 VoIP & VoIP WiFi Electronic Paging Modules
Page 12 of 24
f:\standard ioms - current release\42004 instr. manuals\42004-464b.doc
07/14
Programming and Set Up
N
OTE
: The 10458-701 and -801VoIP and VoIP WiFi Electronic Paging Modules include the same
embedded browser as do GAI-Tronics’ VoIP and WiFi telephones. There are many programmable
parameters utilized by our telephones that are not utilized by the VoIP Paging Modules. All Paging
Modules are factory programmed for maximum operating proficiency. Please do not make any
programming changes other than those directed in this manual.
Opening the VoIP Paging Module Assembly
The VoIP Paging Module must be opened for programming and installation. Bench programming and
testing is recommended. Remove the assembly from the carton and position on a flat surface.
Remove the four screws (two on top and two on bottom) holding the mounting plate to the chassis. The
mounting plate has two finger holes that can be used to remove it from the chassis. Remove the six
screws that are holding the chassis together (two on the rear and four on the side). Refer to Figure 2
below.
Figure 2: Electronic Paging Module Assembly (Model 10458-701 shown)