Outdoor installation product, Antenna care, Electromagnetic interference/compatibility – GAI-Tronics 10458-701 VoIP & VoIP WiFi Electronics Paging Modules User Manual
Page 21: Mechanical receipt inspection, Cable installation safety considerations, Mounting
Pub. 42004-464B
Model 10458-701 and 10458-801 VoIP & VoIP WiFi Electronic Paging Modules
Page 19 of 24
f:\standard ioms - current release\42004 instr. manuals\42004-464b.doc
07/14
Outdoor Installation Product
Power lines - An outdoor system should not be located in the vicinity of overhead power lines, electric
lights, or power circuits, where it may contact such power lines or circuits, as this contact might be fatal.
Refer to the National Electrical Code Article 800 regarding installation.
Antenna Care
Unauthorized antennas, modifications, or attachments could damage the radio and may violate FCC
regulations.
Electromagnetic Interference/Compatibility
Electronic equipment may be susceptible to electromagnetic interference. If you experience interference,
visit the FCC website at http://www.fcc.gov for possible solutions.
Mechanical Receipt Inspection
The Paging Modules are shipped in a cardboard container, protected from movement and distress by a
self-forming packaging material. Thoroughly inspect it as soon as possible after delivery. In-transit
damage should be immediately reported to the transportation company.
Cable Installation Safety Considerations
Interconnecting, communications, and Class 2 dc power cables should be separated from electrical light
or other Class 1 circuits by at least 2 inches. The exception is where Class 1 wiring or power circuits are
run in a raceway, or are metal-sheathed or metal-clad, or are permanently separated from the conductors
of the other circuitry by a continuous and firmly fixed nonconductor such as porcelain tubes or flexible
tubing in addition to the insulation on the wire. Communications cables and in-building wiring should be
listed and marked for the purpose according to NEC Article 800.
Mounting
Remove the access panel from the Model 234 Stanchion (if applicable).
Remove the back plate from the Paging Module by removing the four #6-32 screws.
The Model 12510-002 or Model 12510-003 Access Panel Kit (sold separately) contains four #6-32 studs
to attach the Paging Module. Attach the mounting plate to the #6-32 studs with the provided #6 keps
nuts. Be sure to note the orientation of the access panel when attaching the plate. Refer to Figure 6 and
Figure 7.