Gladiator GASL1TAMDG Licensed Collegiate PrimeTime Locker - Manual (Page 2)

2
CABINET/LOCKER SAFETY
ASSEMBLY INSTRUCTIONS
Tools and Parts
Gather the required tools and parts before starting installation.
Tools Needed
Parts Supplied
Locker Use Requirements
■ Intended for use in a garage and home.
■ Maximum weight limit is 50 lbs (22 kg) for each shelf.
■ Maximum weight limit is 100 lbs (37.3 kg) for the locker.
Unpack the Locker
1. Remove and verify the contents. See “Parts Supplied” in “Tools
and Parts” for your model.
2. Dispose of/recycle all packaging materials.
NOTES:
■ The locker may be mounted directly to a wall stud using the #8 x
2" mounting screws.
■ The supplied hardware requires ³⁄₈" to ¹⁄₂" drywall/wall board for
mounting the locker.
NOTE: Mounting to a wall with a different thickness or a different
material may require new mounting hardware. Customer will be
responsible for consulting a professional for mounting
instructions other than specified in this manual.
■ Lockers can be mounted side-by-side; however, each locker
must be individually mounted to the wall according to the
installation instructions in this manual.
IMPORTANT: Lockers are not designed to be attached to each
other. This locker mounts directly to the wall using hardware
provided. As an option, lockers can be mounted to Gladiator
®
GearWall ® Panels and GearTrack ® Channels using a standard bracket
kit. See the “Accessories” section for information on ordering.
You can be killed or seriously injured if you don't immediately
You can be killed or seriously injured if you don't follow
All safety messages will tell you what the potential hazard is, tell you how to reduce the chance of injury, and tell you what can
happen if the instructions are not followed.
Your safety and the safety of others are very important.
We have provided many important safety messages in this manual and on your appliance. Always read and obey all safety
messages.
This is the safety alert symbol.
This symbol alerts you to potential hazards that can kill or hurt you and others.
All safety messages will follow the safety alert symbol and either the word “DANGER” or “WARNING.”
These words mean:
follow instructions.
instructions.
DANGER
WARNING
■ ³⁄₄" open-end wrench
■
³⁄₈" socket wrench
■ Phillips screwdriver
■ Rubber hammer
■ Combination dial lock
Assembly
■ Combination lock (1)
■ Pull tab handle (1)
■ Cam (1)
■ Cam screw (1)
■ Jam nut (1 - separate)
■ Dual J Hook Assembly
■ #10 – 24 x ¹⁄₂"
pan-head screws (2)
■ #10 - 24 self-locking
nut (1)
■ Dual J hook
■ Mounting Hardware
■ Hollow wall anchors (4)
■ #8 x 2" mounting screws (4)
■ #8 -
³⁄₄" fender washers (8)
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
locker.
Failure to do so can result in back or other injury.