Gladiator GASL1TAMDG Licensed Collegiate PrimeTime Locker - Manual (Page 5)

5
ASSEMBLE COMBINATION LOCK AND HANDLE
1. Facing the front of the dial lock, with the cam facing to the left
and the pull tab handle pointing down, align the dial lock flats
with the flats on the door opening.
2. Angle the combination lock assembly, as shown.
3. Insert the tip of the cam at the angle shown.
4. Rotate the dial lock assembly into the final assembly location, as
shown.
5. From the inside of the door, rotate the jam nut onto the cam and
thread and into the final assembly location. The jam nut should
be flush and snug against the back of the door.
6. The lock combination is preset at the factory to 0-0-0
combination. The lock combination can be changed as follows:
■ Rotate the lock body clockwise 90 degrees to the open
position.
■ Locate the hole in the side of the lock body. The hole will
be located on the left-hand side (at the nine o’clock
position) of the lock body. In this position, the hole will
align with the lock combination reset button inside the
main lock body.
■ Insert a pin into the hole and depress the lock combination
reset button.
■ While holding the reset button in, turn each individual
combination dial to the desired new lock combination
number.
■ Release the reset button to set the new lock combination.
7. To lock, turn the combination dial away from the set combination
number.
NOTE: Maintain a record of your combination. Locks cannot be reset
without the current combination.
A. Dial lock flats
B. Cam C. Jam nut
D. Pull tab handle
A
B
D
C
A. Dial lock threaded body
B. Jam nut final assembly location
A. Pin
A
B
A