Gladiator GASL1TAMDG Licensed Collegiate PrimeTime Locker - Manual (Page 4)

4
Mounting Holes Align with Wall Stud
1. Mark centerline of wall stud and locker mounting holes.
NOTE: Mounting holes that align with a wall stud do not need
wall anchors. The mounting screw and washer will mount directly
to the stud, as shown.
NOTE: When mounting screws on one side to a stud, the screws
on the opposite side will require a hollow wall anchor.
Wall Stud Alignment
2. If the locker can be flush-mounted to the wall, proceed to the
section “Flush Mount to Wall.” If the locker cannot be flush
mounted to the wall (due to baseboard, etc.), go to the section
“Non-Flush Mount to Wall.”
Flush Mount to Wall
1. Using two or more people, move the locker to the wall mounting
location and align the mounting holes in the back of the locker
with the wall anchors an/or stud center lines.
2. Slide a washer onto a #8 mounting screw, and then insert
through the back of the cabinet into the wall anchor and/or stud,
as shown.
3. Using a Phillips screwdriver, turn the screw until it is flush and
tight against the back of the locker.
NOTE: Do not overtighten mounting screws.
4. Repeat steps 2 and 3 for each remaining mounting holes.
Non-Flush Mount to Wall
1. Using two or more people, move the locker to the wall mounting
location and align the mounting holes in the back of the locker
with the wall anchors and/or stud centerlines. Leave
approximately a 1" (2.5 cm) gap between the wall and the back
of the locker to install the spacer and washer.
2. Slide a washer onto a #8 mounting screw and from the interior,
insert through the back of the locker.
3. On the exterior back of the locker, align a spacer and washer with
the end of the screw. Insert screw through the spacer/washer
and into the wall anchor. Tighten three or four turns.
NOTE: Do not tighten screw completely to allow for installation
of the remaining mounting screws/spacers.
4. Repeat steps 2 and 3, for the remaining mounting screw
locations.
5. Completely tighten each mounting screw until the locker is snug
against the wall.
Assemble Dual J Hook to Shelf
1. Unpack and verify J hook components.
2. Insert J hook mounting screws into the mounting holes from the
top side of the shelf.
3. Align dual J hook mounting holes with mounting screws
protruding from the bottom of the upper shelf.
4. While holding the J hook in position, slide jam nut onto the
mounting screw and tighten.
5. Repeat with remaining J hook mounting screw.
A. Wall stud
B. Wall C. Back of cabinet
A. Back of cabinet
B. Fender washer C. Mounting screw
D. Hollow wall anchor
B
C
A
D
A
B
C
A. Back of cabinet
B. Fender washer
C. Mounting screw
D. Spacer
E. Hollow wall anchor
F. Wall
A. #10 – 24 x ¹⁄₂" pan-head screws
B. #10 - 24 self-locking nuts
C. Dual J hook
A
B
C
E
D
F
A
C
B B
A