Gladiator GABK362PSS Ready-To-Assemble Cabinet Bracket Kit - Manual (Page 4)

4
Mount the Cabinet to GearWall ® Panels or GearTrack ® Channel
IMPORTANT:
■ Be sure the GearWall ® panels or GearTrack ® channels are
installed with mounting screws in every slot and at every stud
location with a maximum of 24" (60.96 cm) horizontally between
screws.
■ If GearTrack ® channels will be used to support the Gladiator ®
Large GearBox cabinet, you must use three channels installed
18" (45.72 cm) apart.
NOTE: The three nuts on the center and bottom mounting brackets
must be loose enough to allow the brackets to move in the slots.
1.
Close the cabinet doors.
2. Determine cabinet mounting location on GearWall ® panels or
GearTrack ® channel.
3. Using two or more people, engage the top bracket into the slots
by lifting up, pushing toward the wall and lowering the bracket
rims into the slots as shown.
4. Make sure the top bracket is fully engaged in the slots as shown.
5. Open the cabinet doors.
6. From inside the cabinet, grasp the bolts in the center bracket and
adjust the bracket until it aligns with the slot in the GearWall
®
panels or GearTrack ® channels.
7. Push the cabinet toward the wall and lower the center mounting
bracket into the slots.
8. Make sure the center bracket is fully engaged in the slot as
shown.
9. Repeat for the bottom bracket.
10. Using a ¹⁄₂" wrench, fully tighten the nuts attaching the center and
bottom brackets.
18" (46 cm)
WARNING
Excessive Weight Hazard
Use two or more people to move, assemble or install
cabinet or locker.
Failure to do so can result in back or other injury.
A. Bracket rim
B. Slot C. Mounting bracket
fully engaged
A
B
C