Gladiator GAWG28KDYG Gladiator Ready-To-Assemble 3/4 Wall GearBox - Manual (Page 3)

3
ASSEMBLY INSTRUCTIONS
Cabinet Use Requirements
■ Intended for use in a garage.
■ Maximum weight limit is 40 lbs (18 kg) for each shelf.
■ Maximum weight limit is 150 lbs (68 kg) for the cabinet.
Unpack Cabinet Parts
1. Remove and verify the contents. Contents include a hex key and
the parts and fasteners shown in “Parts.”
2. Dispose of/recycle all packaging materials.
Assemble Cabinet Frame
Gather the required tools before starting installation.
Tools Needed
Tools Supplied
IMPORTANT:
■ Two people may be required to complete the assembly.
■ The cabinet top (P2) is intentionally designed so that the tabs will
only match with the loops on the sides when it is positioned
correctly. If the tabs on the cabinet top do not match up with the
loops on the side panel (P1), turn the cabinet top around.
1. Place side panel (P1) on a flat, firm surface so that the edge with
the loops is facing up.
2. Align the tabs in the cabinet top (P2) with the loops in the cabinet
side (P1). Slide the cabinet top between the edges of side panel.
NOTE: Check that each tab is inserted fully behind the loop.
3. Align the 2 holes in each corner. Using hex-head bolts (F1),
fasten the side panel (P1) to the cabinet top (P2) as shown. Do
not tighten completely.
4. Repeat steps 2 and 3 for the other cabinet side (P1).
5. With the smooth side toward the cabinet interior, align the 4 tabs
in the cabinet bottom (P3) with the loops in the cabinet sides
(P1). Slide the cabinet bottom between the edges of side panels.
NOTE: Check that each tab is fully inserted behind the loop.
6. Align the 2 holes in each corner. Using hex-head bolts (F1),
fasten the side panels (P1) to the cabinet bottom (P3) as shown.
Do not tighten completely.
Attach Back Panels
1. Align the 7 tabs in the upper back panel (P4) with the loops in the
cabinet top (P2) and cabinet sides (P1).
2. Slide the upper back panel (P4) toward the cabinet top (P2) until
the upper back panel is firmly in place.
NOTE: Check that each tab is inserted fully behind the loop, as
shown.
3. Align the 4 side tabs on the lower back panel (P5) with the loops
in the cabinet sides (P1).
4. Slide the lower back panel (P5) upward until the top of the lower
back panel is under the upper back panel (P4).
NOTE: The upper back panel will slightly overlap the lower back
panel.
F1
F1. ⁵⁄₁₆" hex-head bolts (16)
■ ¹⁄₂" wrench ■ Phillips screwdriver
■ Hex key
A. Tab
B. Loop
P2
P1
A B
P2
F3c
F3c. Phillips-head screws (5)
P1
P2
P3
P1
P1
P3
P3
P4
P1
P1